Beer Lid Pin

Introduction: Beer Lid Pin

About: Im invisible. I like creating odd and creepy things cool things weird things scary things destructive things intelligent things dumb things worthless things, shiny things, loud things, obnoxious things, pretty…

this was an instructable i came up with off the top of my head while drinking a corona and only used what supplies that were in arms reach. this is more of a good idea rather than good instructable because im sure many people can do a much better job. i just thought it would be cool to share. thanks!

Step 1: Drink Your Beer

drink your beer and carefully pry the lid open. I didn't think of this instructable until i damaged the lid but continued to proceed with instructable anyhow :D

Step 2: The Stuffing!

what i did, was (and again, supplies in arms reach) cut out a circle piece of cardboard from a minute maid container and cut small notches around the circle and could fold over to flap over some q tip cotton. lol

Step 3: Finish Up!

in the final step there are numerous different things you can do to make this better like add clear tape over the top to give it a glossy look or add super glue for a better seal I also didn't have the actual pin part to add on but again I thought this would be a cool idea to share. carefully fold over edges of cap glue down freshen up add pin and boom! your awesome now in a short period of time :) enjoy

Be the First to Share


    • For the Home Contest

      For the Home Contest
    • Big and Small Contest

      Big and Small Contest
    • Game Design: Student Design Challenge

      Game Design: Student Design Challenge



    7 years ago on Introduction

    I'm sorry, I didn't get a bit the idea what accually do with this unstructable work you show us

    Thank you anyway


    Reply 7 years ago

    it was a rather quick and sloppy instructable, but i was sharing the idea of making pins you can wear or use for decoration.