In this lesson I will show how to make a bluetooth car out of an unnecessary radio-controlled machine.

Step 1: Materials

- Unnecessary RC car

- Arduiono Uno

- Motor Shield

- Bluetooth module hc-05

- battery +7.2V

Step 2: Installation

First you need to disassemble the car. Remove it from unnecessary (old board, bulb and stuff) you need to leave the motors and the switch. Then, according to the scheme, you need to collect all the electronics and install it on the typewriter. After installing the electronics, you need to collect the car back.At the expense of the circuit, the bluetooth module is connected as follows: Rx - A1 Tx-A0 + 5V power, the motor shield is powered from + 7.2V