Christmas Ornament Design Tutorial

Introduction: Christmas Ornament Design Tutorial

Start in SolidWorks

Step 1: Initial Sketch

Because of how the sketch is made, the rings that will be created will be completely independent of the body of the ornament, however they will not be able to come off due to the track they are set in. Effectively this means that these rings will be able to spin once the part is made. Later on I will add in features to each ring and their ability to move will allow for customizable images.

Step 2: Revolved Boss/Base

Step 3: Add in the Top Ring

Step 4: Sweep Boss/Base on Top Ring

Step 5: Add in Faces

Step 6: Add in Middle Sections

Step 7: Add in Bottom Sections

Step 8: Add in Snowflakes

Step 9: Convert File to a .STL File

3D Printed Ornament Design Challenge

Participated in the
3D Printed Ornament Design Challenge

Be the First to Share

    Recommendations

    • Plywood Challenge

      Plywood Challenge
    • Plastic Contest

      Plastic Contest
    • Battery Powered Contest

      Battery Powered Contest

    Discussions