​Copper Spiral Pendant Necklace

648

13

0

Introduction: ​Copper Spiral Pendant Necklace

An interesting design using very little time or materials. Harnessing the beauty of copper, and spinning it around, a circular latren is formed.

Step 1: Spiral

Using fije pliers, hold the very end of the wire. The use the entire straight section to wrap around this little section. Keep spinning and begin bending around the previous spiral, until the pendant is the desired size. Cut leaving a small section to wrap behind the circle.

Step 2: ​Enjoy!

The small straight section on the backside can be used to string the pendent on a cord or chain, ready to show off! Enjoy!

Makerspace Contest 2017

Participated in the
Makerspace Contest 2017

MacGyver Challenge

Participated in the
MacGyver Challenge

Be the First to Share

    Recommendations

    • Water Speed Challenge

      Water Speed Challenge
    • Backyard Contest

      Backyard Contest
    • DIY Summer Camp Contest

      DIY Summer Camp Contest

    Comments