Craftsman Molding Head Tune-up

Introduction: Craftsman Molding Head Tune-up

About: I am a teacher who enjoys environmentally responsible woodworking. Most evenings will find me in the shop working with my now 8 year old son Shay who is both my greatest helper and biggest fan.

These things are everywhere but so very many sit on the shelf because of the piss-poor job they do cutting.  It has been my experience that most of the time that is simply from a rough factory grind or years of use.  In this instructable I talk about how I sharpen my blades to take a rough and ready tool to a silky molding beast.

Be the First to Share

    Recommendations

    • Make it Glow Contest

      Make it Glow Contest
    • First Time Author Contest

      First Time Author Contest
    • Anything Goes Contest

      Anything Goes Contest

    3 Discussions

    0
    JmsDwh
    JmsDwh

    8 years ago on Introduction

    Great Instructable! I especially liked the "Don't let your mother hear you say that." It's too bad that these tools aren't shipped ready to use. Do you use finger boards when you cut with these?

    0
    pfred2
    pfred2

    Reply 8 years ago on Introduction

    That is the nature of many edged tools. You have to hone them yourself.

    0
    NelsonStudios
    NelsonStudios

    Reply 8 years ago on Introduction

    I do for anything but a simple cut or with long boards. They tend to get chattery and that will ruin the crispness of the cut. Most all the time I will use a finger board to hold them against the fence. When doing trim I will also use one to hold them down. It helps to have a helper then to pull the trim the rest of the way though the saw.