Crown and Wall Knot - Hide the Ends

1,470

2

Introduction: Crown and Wall Knot - Hide the Ends

Here is another way I hide the cord ends.

Step 1:

Start with a crown knot. Bring each strand in a counter-clockwise direction, passing over its neighboring strand.

Step 2:

Tie a wall knot beneath it. Take one strand brimg it underneath its neighbor and back out of the way

Step 3:

Repeat with the other strands

Step 4:

Snug the result

Step 5:

Bring one strand over the top of the knot and under one crown knot strand as shown. Tighten.

Step 6:

Repeat with other strands

Step 7:

With hemostat go through the center of the knot into any of the four openings, grab the appropriate cord and pull it through

Step 8:

Repeat with the remaining strands

Be the First to Share

    Recommendations

    • Tinkercad to Fusion 360 Challenge

      Tinkercad to Fusion 360 Challenge
    • Go Big Challenge

      Go Big Challenge
    • Stone Concrete Cement Contest

      Stone Concrete Cement Contest

    Comments