Custom Knex Motorcycle/Dirt Bike

This is a completely custom bike that I made while I was fooling around with my friends and one of them noticed that a black Y connector fit on the end of a rod and I thought it would make a cool bike axle and so I came up with this. It comes complete with a bounce spring loaded seat, wheels that spin and handlebars that turn (even though they don't do anything).

Part List
- 3 white half connectors
- 4 green connectors
- 1 brown straight connector
- 2 white V connectors
- 2 blue rings
- 6 small black Y connectors
- 1 blue rod
- 6 silver/white/black rods
- 8 black tiny rods
- 2 of the smaller wheels

Estimated Time
- I don't know probably somewhere in between 5 - 10 minutes

Difficulty
- 1/5 Anyone can probably do this.

Step 1: Construct Frame

Construct the frame according to the pictures. Don't forget to make 2 of them.

Step 2: Connect Frame Sides

The pictures are pretty self explanatory. The magic of the springy seat lies in the rod with the two rings that goes on the bottom of the upper green connector and pushes one side of the handlebar connector up (but that's later).

Step 3: Assemble and Attach Wheels

This step is very easy and the pictures say it all.

Step 4: Assemble and Attach Handlebars and Seat

This step is again easy and can be done with the pictures. After you have finished that you are done. Congratulations, enjoy and thank you for building a Ginosmooth instructable.