Custom Skateboard/Nickle Board
Intro: Custom Skateboard/Nickle Board
make your own custom cruisor or skateboard bare with me its my first instructable and I'm 17
STEP 1: Items Needed
hacksaw
sandpaper
sparverathane
skateboard tool
wood burner
pencil
sandpaper
sparverathane
skateboard tool
wood burner
pencil
STEP 2: Prepare Board
ok so first step is to sand the bottom of the board until you get to bare wood after that draw your board design on your board
STEP 3: Start Cutting
using your hack saw (would reccomend keyhole saw) begin to cut out around your traced design
STEP 4: Finish Cutting Then Use Design for the Actual Skateboard Bottom
lay out design on board and tape down after you have added either graphite or transfer paper to the back then trace over the design
STEP 5: Once Traced Begin Burning Design Into Wood
using wood burner carefully burn design into wood this is the longest part of the whole process
STEP 6: Apply Sparurathane or Any Other Marien Grade Wood Sealer
apply as many coats as specified on can I put 7 layers on mine
STEP 7: Put It All Together
assemble all the pieces together and enjoy. altogether it took me a total of a month and a half to make mine
2 Comments
Chad Fournier 8 years ago
seamster 8 years ago
I thought I had left a comment here, but it's missing! : |
This is a great looking mod to the board. Very nice lines, and a thoughtful gift for your lady. Well done!