DIY 5 Ton Hydraulic Press

By bubal in Circuits Tools

17,219

How to make a homemade hydraulic press with a car jack, u channel steel (u beam) and threaded bar. It is not finished. The jack should be bolt down or attached to the base and the base to the table.

Be the First to Share

Recommendations

How to Make a Voltaic Pile - the World's First Battery by christophersfactory in Electronics

17 3.3K

AI-assisted Pipeline Diagnostics and Inspection W/ MmWave by Kutluhan Aktar in Microcontrollers

2 1.0K

KoiBoard - Fully Customizable Mechanical Keyboard With a Koi! by salilkhare65 in Electronics

39 4.2K

Print, Paint, and Program a Guardian to Track Humans and Dogs Using a Pi, Camera, and Servo by npentrel in Raspberry Pi

56 3.8K

For the Yard
3D Printing Student Design Challenge
Repair and Reuse Contest

3 Comments

oohlah

9 years ago

Just a photo, needs more data.

phydraulic

9 years ago on Introduction

It is very simple to install and use. It is really useful for household pressing purposes. Too small and high power! http://www.precisehydraulic.com/hydraulic-power-packs.htm

FrankenPC

9 years ago on Introduction

Nice. I need one of these. It's small and light enough to be usable in a normal sized garage. Thanks!

Introduction: DIY 5 Ton Hydraulic Press

Be the First to Share

Recommendations

For the Yard

3D Printing Student Design Challenge

Repair and Reuse Contest

3 Comments