DIY Accessibility

Introduction: DIY Accessibility

Supplies needed:

Blouse

Buttons

Thread and Needle

Scissors

Velcro

Step 1: Step 1: Cut Velcro Pieces 1/2 Inch

Make sure to cut 1/2 inch pieces for each button on the blouse

Step 2: Step 2: Sew the Button to One Piece of Velcro

This step may be tricky:

insert needle into button and make sure to put needle through every hole so that the button does not come undone

Step 3: Step 3: Once Button Is Sewed on Tightly Cut Thread

Once secured onto the velcro piece, cut any excess thread off

Step 4: Step 4: Inset Button to One of the Pre-existing Holes in Blouse

Make sure button fits correctly into the hole

Step 5: Step 5: Attach Other Piece of Velcro on Opposite Side

Sew on the other side of the velcro and you are done!

Be the First to Share

    Recommendations

    • Tinkercad Student Design Contest

      Tinkercad Student Design Contest
    • Space Contest

      Space Contest
    • Plastic Challenge

      Plastic Challenge

    Comments