DIY CARDBOARD LAPTOP STAND

Introduction: DIY CARDBOARD LAPTOP STAND

About: I am a DIY hobbyist by passion and Power Engineer by profession. Most of my works are related to Solar Energy and Arduino. Apart from Electronics I love 3D printing, Woodworking and to make crafts from used …
Manly Crafts Contest

Participated in the
Manly Crafts Contest

Workshop Contest

Participated in the
Workshop Contest

1 Person Made This Project!

Recommendations

  • Fandom Contest

    Fandom Contest
  • Water Speed Challenge

    Water Speed Challenge
  • Pets Challenge

    Pets Challenge

2 Comments

0
megadarkwood
megadarkwood

7 years ago

some holes in the back or an exhaust fan would be nice

0
opengreenenergy
opengreenenergy

Reply 7 years ago on Introduction

When I place my laptop , found that around 3mm gap is there in the back side and small gap in two end stand .So I thought it is sufficient for ventilation even without the fan..But if after keeping your laptop there is no gap then it is better to make some holes for ventilation...