Introduction: DIY Lego Cell Phone Holder/Charger

This is just one of those ideas hat just pop in your head for no apparent reason. I was bored and This idea just came in. Using a diagram I made up in my head(impossible to convert to JPG, PNG,PSD, etc.), I started building it. Heres the video:

Step 1: Step 1: Materials

This part is pretty obvious:

Lot's of Lego's
Cell phone
Cell phone charger

Step 2: Step 2: Wire Up

You can put as much wires as needed, though for this were just using the charger. The pictures below will kind-of explain my method / example(Note(not really) that all of the following pictures were taken with a Fujifilm Finepix S1000, not that it would interest you):

Step 3: Step 3: Finish and Revise Till Perfection or Needs

In the video, the first one was very breakable, unstable, and not good looking for starts. I later modified it by removing extra pieces and using them to connect the sides(except the front). It made it look nicer, and more stable. Remember to keep size in perspective, or else it might end up too big or too small.