DIY PVC Gopro Stabilization Bracket

Introduction: DIY PVC Gopro Stabilization Bracket

About: Follow me on Youtube

This DIY video will show you how to make a PVC Stabilization bracket for a Gopro or other small-medium sized camera bracket. There is also the possibility to make it slighty larger so you can put a light and a microphone on it.

To make this bracket it will cost you less than 10 USD depending on the place you buy it.

Enjoy! And Subscribe!

Be the First to Share

    Recommendations

    • Make it Glow Contest

      Make it Glow Contest
    • First Time Author Contest

      First Time Author Contest
    • PCB Challenge

      PCB Challenge

    2 Discussions

    0
    Battlespeed
    Battlespeed

    6 years ago on Introduction

    Wouldn't that be even more stable with the heavier light at the center of gravity and the camera on top? The arrangement you have seems top-heavy, and I don't think switching the light and camera would have any adverse impact on the video.

    0
    Arabian Outdoors
    Arabian Outdoors

    Reply 6 years ago on Introduction

    Thanks for commenting

    I just tried your recommendation and it works very well on the small mount that was being built in the video. However I primarily use the large mount shown at the end of the video, on that mount I only ever really use the mic so when I tried mounting the Gopro instead of the light the mic would be in the shot of the Gopro.

    Thanks for the advice I will use it when I am using the small mount with the light!