Introduction: DIY Shoelace Anchors - No Knots. No Bows.
My shoelace anchors are really useful and saves you a lot of time by tying your shoes.
They are very simple to make and work with any type of shoe laces.
WATCH my Video Tutorial HERE on Youtube: DIY - Shoelace Anchors - No Knots.No Bows.
or/and follow the STEPs down below.
When you've done:
Put the lace ends just flat under the shoe sole or as you can see in the video along the hack....
Of course you can also cut the other laces .... but then you have no longer the option to tie up your boot or shoes solid after a while.
Try it. It saves a lot of time.
☺Enjoy and subscribe for FREE today☺
►►►Visit my Facebook-Fanpage !◄◄◄
► https://www.facebook.com/ehlerstv ◄
►►►Follow me on Twitter ! ◄◄◄
► https://twitter.com/Ehlers_TV ◄
Step 1: You Need
- Your shoes
- 4 little washers per shoe (2 per end)
Step 2: Start
Put the first end of your shoelace throgh 2 washers.....and drag washers on the lace.
Step 3: Next Step
Then put the end over the first washer and through the second....
Step 4: Next Step
Pull the lace through....
Step 5: Next Step
Drag the washer towards shoe....and hold the other one.....
Step 6: Next Step
Fix the one on the shoe and pull the lace through until it goes no further.....
Step 7: The End
Put the lace ends just flat under the shoe sole or as you can see at the pic (along the hack)....
Of course you can also cut off the laces .... but then you have no longer the option to tie up your boot or shoes solid after a while.
Step 8: Ready
Ready ! No knots. No bows. No tying......pretty simple !!!
Have a nice day.
By the way: These steps are only for one end....logically, it must be repeated for each end of your shoelaces :-D