DIY Table Mono-pod With HARD DISK

Introduction: DIY Table Mono-pod With HARD DISK


Hi everyone I'm back with a simple DIY Table Mono-pod for camcorder and camera.
You will need :
 - Used hard disk
 - Thread Aluminum tube
 - Srew x2

So it's simple just open the hard disk and empty it. Keep the chassis and the cover. Drill the cover and screw it up to the aluminum tube.
Screw up the other side to the camcorder
and done !



Be the First to Share

    Recommendations

    • 3D Printed Student Design Challenge

      3D Printed Student Design Challenge
    • Unusual Uses Contest

      Unusual Uses Contest
    • Hour of Code Speed Challenge

      Hour of Code Speed Challenge

    2 Comments

    0
    miika191
    miika191

    Reply 10 years ago on Introduction

    It's really stable, because the hard-disk is very flat. I think I'll put wheels^^