Introduction: DIY Vintja Keyhole Charm Bracelet
Easy charm bracelet for beginners.
Step 1: Tools Needed
To make a bracelet like this one you will need a pair of round nose pliers, and two curved chain nose pliers.
Step 2: Supplies
Vintja keyhole
Antique brass lobster clasp
Key charm
Heart charm
Freshwater pearl
Antique brass headpin
3 Jumprings
Two sizes of chain- (3 pieces of small chain 3 3/4", and one larger chain 2 1/4") These lengths added to my keyhole, clasp, and jumprings will fit up to a 8" wrist.
Antique brass lobster clasp
Key charm
Heart charm
Freshwater pearl
Antique brass headpin
3 Jumprings
Two sizes of chain- (3 pieces of small chain 3 3/4", and one larger chain 2 1/4") These lengths added to my keyhole, clasp, and jumprings will fit up to a 8" wrist.
Step 3: Connecting Larger Chain
First take your headpin with pearl and make a wire wrapped loop on one end.
Take one jumpring, larger chain, key charm, wire wrapped pearl, and connect to one side of vintja keyhole.
Step 4: Connecting the Three Chains
Now take your three smaller pieces of chain and connect them to the other side of your keyhole with a jumpring.
Step 5: Adding Your Clasp
Use a jumpring to add your lobster clasp, and heart charm to the other end of your three smaller pieces of chain.
That's all there is to it. Wasn't that easy?
That's all there is to it. Wasn't that easy?