Disney Castle (Landmarks)
Intro: Disney Castle (Landmarks)
I wanted to 3D print a Disney Castle but I could not find any closely accurate ones so I made it myself.
STEP 1: The Base
I went to Disney World and looked at the Disney Castle and thought that I wanted to have my own. So I started this print with a 14 sided figure and added towers to its sides and cut out the back. I also remember walking through a tunnel to the other side so I made that.
STEP 2: A Little Detail
I added some more of the Disney Castle that was on the "First Level".
STEP 3: Basic Build Up
I then added the main middle part but did not add much detail yet.
STEP 4: ITS DONE!!!!!
I finally completed it. Adding in the rest.
Comments
Penolopy Bulnick 3 years ago