Don't Go Bacon My Heart

933

6

1

Introduction: Don't Go Bacon My Heart

This box contains 2 separate containers and a lid. The lid does not latch in place so be careful with what you put inside. Note: I did scale my design down to 40% so it could fit on my printer.

You will need:

  • Glue gun
  • 3D printer
  • Box design:

Step 1: Printing

1. Use the provided file to print out the box heart

Step 2: Assembling

2. Conect the lid to the heart shaped box and insert the rod into the joints.

Step 3: Glueing

3. Take the hot glue gun and put a glob of hot glue on each end of the pin to secure from sliding out of the joints.

Design Now: In Motion Contest

Participated in the
Design Now: In Motion Contest

Be the First to Share

    Recommendations

    • Anything Goes Contest 2021

      Anything Goes Contest 2021
    • Fix It Speed Challenge

      Fix It Speed Challenge
    • Jewelry Challenge

      Jewelry Challenge

    Comments

    0
    DIY Hacks and How Tos

    That looks really nice. That would make a great Valentine's day project.