Introduction: EASY MSP430 LaunchPad ISP With Only 4 Wires!!!
More by the author:
About: 重度網路程癮者
now, i would like to show you how to turn your own launchpad into a ISP with only 4 wires!!!
this is my first time to post instruction, I am a senior high student,
sorry for my poor grammar.
in the example i use MSP430G2231, but you can replace it with any 430 families chip, whether 14pins or 20pins
=============================
Need list:
1. only 4 dupont wires (with one side male and other side female)
2.launchpad breadboard
this is my first time to post instruction, I am a senior high student,
sorry for my poor grammar.
in the example i use MSP430G2231, but you can replace it with any 430 families chip, whether 14pins or 20pins
=============================
Need list:
1. only 4 dupont wires (with one side male and other side female)
2.launchpad breadboard
Step 1:
connect them like followings, this example is 14pins chip
Vcc <---> pin1
GND <---> pin14
TEST <---> pin11
RST <---> pin10
if your chip is 20pins, you can do like this
Vcc <---> pin1
GND <---> pin20
TEST <---> pin17
RST <---> pin16
Vcc <---> pin1
GND <---> pin14
TEST <---> pin11
RST <---> pin10
if your chip is 20pins, you can do like this
Vcc <---> pin1
GND <---> pin20
TEST <---> pin17
RST <---> pin16
Step 2:
if previous picture is not clear, maybe this can help you,
Step 3:
at last, you can upload your program by Energia or CCS something else
and it done!!
hope you enjoy~~~
and you must want to know how to make your MSP430 IC work independently(without launchpad board)
and it done!!
hope you enjoy~~~
and you must want to know how to make your MSP430 IC work independently(without launchpad board)