Extendable Arm

Introduction: Extendable Arm

Have you ever wanted to grab something out of your reach, yet, are too lazy to get up? Well now you can by 3D printing this device.

Step 1: Printing

To print, you just have to download the file above and send it to your printer via SD card or flash drive.

Step 2: Setup

To put the device together, you will see the two rods that you must snap together. Slide the pegs into the slots on the cylinder and then screw the cylinder into place.

Be the First to Share

    Recommendations

    • Sew Warm Speed Challenge

      Sew Warm Speed Challenge
    • Make it Glow Contest

      Make it Glow Contest
    • First Time Author Contest

      First Time Author Contest

    Discussions

    0
    Swansong
    Swansong

    3 years ago

    Those are fun :)