Fallout 10mm Pistol

Introduction: Fallout 10mm Pistol

this 10 mm pistol is for my vault 101 jump suit cosplay from fallout 3 .

Step 1: Printing and Treating

i printed these pieces on my lulzbot mini with black esun ABS in 7 hours and 22 minutes and was treated for 4 hours in acetoneso here's the file for printing. P.S sorry if this instructible sucks its my first one ever

Step 2: Gluing and Painting

glue the two pieces together (I glued this with a lot of super glue ) after the glue dries you just paint it to your liking .

sorry for how short this is so short i just didn't have much to say on it.

Step 3: Final Product

Halloween Props Contest 2015

Participated in the
Halloween Props Contest 2015

Be the First to Share

    Recommendations

    • Plastic Contest

      Plastic Contest
    • The 1000th Contest

      The 1000th Contest
    • Battery Powered Contest

      Battery Powered Contest

    6 Discussions

    you used a 3d printer right, and does it work with papercraft and pepakura

    0
    the fireymadman
    the fireymadman

    Reply 4 years ago

    Sadly no it doesn't , i'm relatively new to 3d modeling. sorry.

    0
    Penolopy Bulnick
    Penolopy Bulnick

    5 years ago

    Looks good :) Did you design it or did you find the file online?

    0
    the fireymadman
    the fireymadman

    Reply 5 years ago

    Kinda I found a rudimentary model online with minimal detail so I added all the details in myself.

    0
    Penolopy Bulnick
    Penolopy Bulnick

    Reply 5 years ago

    Awesome job with the details :)