Filling Bottles Off Krups Beertender

Introduction: Filling Bottles Off Krups Beertender

So this instructable is dependent on this one:

I was looking for away to fill either bottles or growlers off my little Beertender. Just using the regular spout I would get a good deal of foam, and this is the very simple and very effective solution I came up with.

Step 1: Step 1: Chill Bottles

Stick however many bottles you want to fill in the fridge, and let them chill about 30 minutes. This reduces foam

Step 2: Step 2: Remove Plastic Spout

It just unscrews, just like you do for cleaning.

Step 3: Step 3: Install Tube

Cut a piece of 5/16" to length, I didn't measure mine...I just eyeballed it.

But as you can see, it fits snugly over the end of the internal faucet

Step 4: Step 4: Turn Off Your Air and Fill Bottles

Its as simple as it sounds: Turn the air off, put the tube in the bottle and open the tap.

Be the First to Share


    • Big and Small Contest

      Big and Small Contest
    • Game Design: Student Design Challenge

      Game Design: Student Design Challenge
    • Make It Bridge

      Make It Bridge