Introduction: Friendship Bracelet Designs - How to Make a Friendship Bracelet DIY29
Step 1: Cut Two Pieces of Cords That Are at Least 40 Inches (1 Meter) Long.
Now there two cords are 40 inches (1 meter) long each, and the other one is 120 inches (3 meters) long. Then, get the 2 short cords together with an overhand knot in the middle place.
Step 2: Pull the 120 Inches (3meters) Cord and Start Braid Bracelet by Using the Square Knot. Then String an 8mm Black Agate Bead With the Middle of Two Cords.
Step 3: Starting With the Outer-right Cord, Tie a Backward Knot (as Shown) Make a Ninety Degree Angle With the Tying Cord Over the Top of the Cord You Are Tying It To.
Step 4: Now Pick Up the Outermost Cord on the Left Side and Make a Forward Knot by Creating a 4-shape Over the 2nd Cord.
Step 5: Repeat the Same Steps 3 and 4. Continue Braiding Still Reach the Length That at the Bottom of Black Agate Bead.
Step 6: Pull the Longest Cords, and Continue Braiding Bracelet by Using the Square Knot.
Step 7: Repeat the Same Process for the Next Cords.
Step 8: Every Now and Then Please Note to Check the Length Against Your Wrist. Stop Braiding When Reach Your Desired Length.
Step 9: String a 6mm Black Agate Bead With the Middle of Cords.
Step 10: Trim the Excess Cord and Burn the Tails of Cords.
Step 11: Your Diy Friendship Bracelet Is Finished.
Trash to Treasure Contest
Tinkercad to Fusion 360 Challenge