Futuristic Martian Tree Sculpture Made With Aluminium Poured in to Orbeez
Intro: Futuristic Martian Tree Sculpture Made With Aluminium Poured in to Orbeez
I end up with a Mars bonsai tree sculpture made by pouring molten aluminium in a bucket full of Orbeez.
This statue is very easy and you can make it if you have a foundry.
STEP 1: Pour a Bag of Orbeez on a Bucket of Water
Pour a bag of orbeez on a bucket of water
STEP 2: Wait 3 Hours and Give Time the Orbeez to Grow
Wait 3 hours and give time the Orbeez to grow
STEP 3: Melt Some Aluminium on the Foundry
Melt some aluminium on the foundry
STEP 4: Pour the Molten Aluminium in to the Bucket
Pour the molten aluminium in to the bucket
STEP 5: Remove the Aluminium From the Bucket
Remove the aluminium from the bucket and remove the orbeez
STEP 6: Make a Basement of About 12x12 Cm
Make a basement of about 12x12 cm, draw it on a piece of wood
STEP 7: Saw the Basement
Saw the basement
STEP 8: Sand the Basement With 300
Sand the basement with 300 sandpaper
STEP 9: Make a Hole in the Basement
Make a hole in the basement and also on the aluminium statue
STEP 10: Varnish the Basement
Varnish the basement
STEP 11: Use an Screw to Hold the Statue
Use an screw to hold the statue on the basement
3 Comments
liquidhandwash 5 years ago
https://www.aluminum.org/resources/electrical-faqs...
http://www.hazardexonthenet.net/article/151491/Rai...
johnip4 5 years ago
TheInstructableTinkerer 5 years ago