Introduction: GTP USB PIC PROGRAMMER (Open Source)
This work includes, GTP USB (not plus or lite) .
The schematic, photos and PCB have been developed by PICMASTERS based on
some valuable works done before.
This programmer supports pic10F, 12F, 16C, 16F, 18F,24Cxx Eeprom.
Unfortunately, it works with only Winpic800 v.355.
We have succesfully tried it with some pics; PIC18F252, 18F2455, 18F2550,
18F2520, 16F84, 16F628 and 24C32 eeprom.
The best and fastest method of pic programming.
All you need (hex file, winpic800, schematic, PCB board in ARES)
are included.
You must program pic18F2550 with hex file by a classical programmer.
Just leave a good fedback for us.
The schematic, photos and PCB have been developed by PICMASTERS based on
some valuable works done before.
This programmer supports pic10F, 12F, 16C, 16F, 18F,24Cxx Eeprom.
Unfortunately, it works with only Winpic800 v.355.
We have succesfully tried it with some pics; PIC18F252, 18F2455, 18F2550,
18F2520, 16F84, 16F628 and 24C32 eeprom.
The best and fastest method of pic programming.
All you need (hex file, winpic800, schematic, PCB board in ARES)
are included.
You must program pic18F2550 with hex file by a classical programmer.
Just leave a good fedback for us.
Step 1: Circuit Scheamatic
circuit schematic. You can see the type and value of the companents.
Step 2: Circuit Layout
Circuit layout.
Step 3: Top Layer
top layer lay out.
Step 4: All of the Documantries
You can find usb driver, layout of the circuit , all of the pics of the circuit, and hardware setting program
Attachments
Step 5: Pics
COLLECTING THE DATA IS ONLY THE FIRST STEP OF THE WISDOM, BUT SAHRING DATA IS THE FIRST STEP OF COMMUNITY.