Introduction: Generative Jewelry

By

The goal is this project was to design generative jewelry using Fusion 360 Generative design feature.

Supplies

  1. Fusion 360 (educational license)
  2. Cura slicer
  3. Ender 3 - 3D printer
  4. PLA filament

Step 1: Inspiration

This images were exported from Pinterest.

Step 2: Design

Since I am still learning how to use the Generative tool of Fusion 360, I created several earing designs to have a variety of generative studies and observe which parameters gave me the desired outcome. However, non of my designs turn up as I was expecting. I think that I am not assigning the design space and conditions correctly.

Step 3: Only Generative Design

After all my failed attempts I tried assigning two preserved geometries that were on top of each other and closing that space between them with a starting shape geometry.

Step 4: Next Steps

I will continue to edit my four basic designs until reaching a generative design that can be printable and appealing (like the outcome presented in the inspiration section).