Here you will learn to make copper tipped spear

Step 1: Whack a Copper Mole

Now you get to take your frustration out on a poor innocent piece of copper

Step 2:

Excuse my cheap camera and bad lighting in my basement

Step 3: Get to the Point

Now you have a crude dull point. Pound it on the edges until you get a point

Step 4: A Sticky Situation

Now tape or tie the blade on

Step 5: Almost There

Vola! Your done! And I am not responsible for any stupid or dangerous ideas you get from making this, I'm only responsible for my own.

Be the First to Share

Recommendations

Stitch and Glue Canoe With Cedar Strip Top by georgechapman in Water

45 4.1K

Building a Backyard Rocket Fort by Garage_Shop_Crafter in Woodworking

56 5.4K

Treats (cakes) for Birds by Ivan Beldiagin in Backyard

38 4.5K

Be Seen! 3D Printed Bike Lights With Fusion 360 by Kevr102 in Bikes

32 4.7K

Colors of the Rainbow Contest
Electronics Contest
Digital Fabrication Student Design Challenge

6 Comments

DanyN1

4 years ago

Hello!

I have some questions. When you say "Pound it on the edges until you get a point"? you mean as in flatten it? as in bend it? ar as in push the rest of the material to the center?

Do you know what was the original gauge of your copper piece?

Thank you very much.

wolf996

10 years ago on Introduction

Hey Feel Free To Comment!!!

Introduction: Copper Spear