Introduction: Gloving Flower LED
Maker : Deepak
Location : Banjaraplya E4D Makerspace
I did this gloving flower LED in Banjaraplya E4D Makers pace.
Material:
- LEDs
- Wires
- paper
- Battery holder and battery
- Switch
Tools
- Electric tape
- Solder
Step 1: Make the Flower
Make the flower has shown in image.
Step 2: Fix the Wires to Battery
Fix the wires to battery has shown in image.
Step 3: Put the Switch
Put the switch has shown in image.
Step 4: Fix the LED
Fix the LEDs to the wires has shown in the image.
Step 5: Put the LEDs Into Flower
Put the LEDs into the hole in the flower has shown in image.
Step 6: Finally My Project
Finally my project is finish and it look like this.