GoPro Vlogging or Selfie Setup Using 3d Printed Parts

Introduction: GoPro Vlogging or Selfie Setup Using 3d Printed Parts

About: I am a mechanical engineer. I like to design equipment and improve other designs :)

these 3d printed parts alow you to use gopro hero action camera as a selfie or vlogging camera !

Step 1: USING PARTS

3d printed parts

1. vlogging adapter for gopro hero http://www.thingiverse.com/thing:2039994

2.GoPro Knuckles http://www.thingiverse.com/thing:2039994 ===================================================

3. gopro hero aluminium cover http://www.thingiverse.com/thing:2039994

4.Universal Smartphone Holder Mount http://www.thingiverse.com/thing:2039994

5.tripod screw http://www.thingiverse.com/thing:2039994

Step 2: Thank You

If you have any comments or suggestions about this design, please don't hesitate to comment below!

Be the First to Share

    Recommendations

    • Make it Glow Contest

      Make it Glow Contest
    • First Time Author Contest

      First Time Author Contest
    • Anything Goes Contest

      Anything Goes Contest

    2 Discussions

    0
    seamster
    seamster

    4 years ago

    Nice! Looks like a good setup. Thanks for sharing :)

    0
    ahmedyashar
    ahmedyashar

    Reply 4 years ago

    thank you