Grabber
Intro: Grabber
It uses 3 sensors .i.e. 1 SRF05 and 2 GP2D12 to detect objects and decide whether the object should be picked up or it should be avoided.GP2D12 were not stable enough so i soldered ..50uF capacitorsbetween the ground and Vcc.I used a 10 RPM Dc gear motor for the arm.It gives around 8-9 Kg of torque at 9V.
The gripper is homemade and uses a towerpro Mg995 servo.
The brain is a Picaxe 28X1 board.
The robot is not yet completed as you can see the robot is not able to turn properly.Have to fix that and some programming is left.
I will be making a bigger and better version of this robot soon.
The gripper is homemade and uses a towerpro Mg995 servo.
The brain is a Picaxe 28X1 board.
The robot is not yet completed as you can see the robot is not able to turn properly.Have to fix that and some programming is left.
I will be making a bigger and better version of this robot soon.
5 Comments
Husham Samir 11 years ago
me_sumit 12 years ago
deadhellguy 12 years ago
albinvadakkekara 12 years ago
how did you made the arm of the robot?
kawal24 12 years ago
Its just a piece of acrlic which is screwed on the arm motor.