Headphone Holder

Intro: Headphone Holder

This instructable will show you how to make a headphone holder using only-
-Scissors
-A Piece of Cardboard
-Pen/Pencil/Sharpie
This is an easy project and should only take a couple of minutes.

STEP 1: Step 1

First, draw this shape on the piece of cardboard.

STEP 2: Step 2

Cut out the shape.

STEP 3: Step 3

Cut a small strip of cardboard out on each side of the shape and cut out a small hole. You may want to put a hole at the end of each of the openings on the side for the cord to slip in to (not shown).

STEP 4: Step 4

Put the auxiliary plug into the hole, wrap the cord around the cardboard and slide the cords into the opening (Make the openings smaller than in the picture or otherwise the cord will come out)

Comments

[sfcsarah]

by wrapping the cord into such tight knots, it only makes it more likely to break

[sfcsarah]

I think if you made the cord wraparound part much wider, it might be better.

[darklucifer]

nice will be perfect to hold my mums earphones my mum washed her set of these earphones in her jacket and then dried them in the dryer without knowing and they still work, no audio loss or crackling or anything like that.