Homemade Bandsaw Box

Introduction: Homemade Bandsaw Box

About: I like to make stuff!

Made out of birch plywood and love.

Step 1: Glue Up

This box is made out of 3/4 inch birch plywood layered using Titebond II wood glue.

Step 2: Hollow It Out

Then taken to the bandsaw and hollowed out.

Step 3: Add Top and Bottom

I cut a separate piece of 3/4 inch birch ply for the top and used a nice scrap of 1/4 inch ply for the bottom just so it wouldn't look like a stack of wood with hardware on it

Step 4: Finish It Up!

I then went to the hardware store and bought some brass hardware. I rounded over the edges just to make it look more uniform.

Homemade Gifts Contest 2016

Participated in the
Homemade Gifts Contest 2016

Be the First to Share

    Recommendations

    • Pi Day Speed Challenge

      Pi Day Speed Challenge
    • Trash to Treasure Contest

      Trash to Treasure Contest
    • Sculpt & Carve Challenge

      Sculpt & Carve Challenge

    3 Comments

    0
    4DIYers
    4DIYers

    4 years ago

    Well done, thank you for sharing :)

    0
    Maker2_0
    Maker2_0

    Reply 4 years ago

    I took the 3/4 inch plywood and stacked it 3 high and glued it then cut into the blank and cut out a square on the inside so I mad it hollow