Introduction: Homemade LM317 Bench Power Supply
This is my first real project in electronics! I started by looking at the schematic and scratching my head a lot then just went for it!
I put the bits and bobs on the board and soldered them into place, wasn't really sure how or where to put the bits. Then i started soldering the wires as in the schematic that's easier said than done! after a few hours things started to come together, i finished the board and tested and to my amazement the psu worked! i would like to show afew pics and the schematic i used.
I put the bits and bobs on the board and soldered them into place, wasn't really sure how or where to put the bits. Then i started soldering the wires as in the schematic that's easier said than done! after a few hours things started to come together, i finished the board and tested and to my amazement the psu worked! i would like to show afew pics and the schematic i used.