Hot Wheels Plexiglass Ramp

Introduction: Hot Wheels Plexiglass Ramp

Give some speed to your kids hot wheels.

Step 1: You Need

Two pine board
The glass from a Ikea Nyatt Frame
Some Tools

Step 2: Make It

After some tries I've got the right shape. Saw the first board, report on the other one and saw it two.

Step 3: Assemble

Take care plexiglass is very weak, do not tight to strong. Sharp the edges with sand paper.
Let's roll.

Be the First to Share

    Recommendations

    • Plywood Challenge

      Plywood Challenge
    • Battery Powered Contest

      Battery Powered Contest
    • Plastic Contest

      Plastic Contest

    3 Discussions

    0
    crapflinger
    crapflinger

    6 years ago on Introduction

    as an improvement on the idea, if you were to route out a groove 1/4" from the curved edge you could just slide the plexi into the groove instead of using the screws which would help in reducing the chances of shattering the plexi, and it would also give you some nice track edges to keep the car in the lane so they don't spin out going down the ramp.

    0
    ErwanJez
    ErwanJez

    Reply 6 years ago

    Great idea, I'll need a new tool :

    temp_-1511376795.jpg