Introduction: How to Make a Light for Your Glovebox at Night
This instructable will show you have to make this cool little three bulb light for your glove box at nite! It is very bright and easy to make with limited tools. Please vote for this instructable at the top of the page if you'll like it. Thanks!
Step 1: Getting Materials!
Soldering gun/pen
Tape
Tube (you could use a toilet paper tube)
Two wire strips (about 5" long)
Soda tab
Christmas lights
Drill or knife
Wire strippers
Step 2: Making the Holes
Make three holes in the tube for the lights to go through. You can use a drill or a knife. Mine are an inch apart. It's up to you how far apart you want them.
Step 3: Solder the Wires Together
Only solder at the yellow highlights where there are arrows.
Step 4: Put It All Together
Put all of the bulbs in the holes you make and thread the two in soldered wires through to smaller a holes to make a switch.
Step 5: Thanks for Reading PLEASE VOTE
Please vote! If I get 100 votes I will make another instructable. Every vote counts. Thanks guys!

Participated in the
Glovebox Gadget Challenge

Participated in the
Tech Contest
11 Comments
8 years ago on Introduction
Using a pop tab as a switch is genius!! Good job!
8 years ago
Thanks so much guys!
8 years ago on Introduction
Great Job!! Put my vote in for you!
8 years ago
Thanks please vote!
8 years ago
Yes you could just use a flashlight however a flashlight focussed on a small spot. This eluminates the entire glovebox.
8 years ago on Introduction
I have a similar device in my own glovebox. I believe it's called a "flashlight".
8 years ago
Thank you.
8 years ago
Nice job! Haha I like your clever use of pop tab.
8 years ago
Yes their are instructions. I'm sorry yours didn't load them. I,d appreciate if u voted anyway.
8 years ago
I missed the instructions ...... Were there any ?
8 years ago
Thanks it actually wasn't my idea. Wish it was.