Introduction: How to Make Wireless Electricity Transmission Circuit - DIY (Step by Step)
Step By Step ( Even Soldering The Components ) Video On How To Make Simple Circuit Transfer Electricity Wirelessly . Its Amazing Project Also Its Very Chip And As Always Its Fun To Make . Anyone Is Welcome To Make Suggestions For Improvements. Good Luck With The Project!
Step 1: What You Will Need ?
Components :
Transistor 2N2222A (NPN)
Resistor 1K Ohm
Copper Insulated Wire
LED
Some Wires
Step 2: Circuit Diagram :
Step 3: How to Make It ?
Step 4: Contact Us & Support Me
Support Me With Like , Share , Subscribe Or Vote To My Instructable
YouTube : https://www.youtube.com/c/zhyarshexazard
Facebook : https://www.facebook.com/c/zhyar.shexazard.2

Participated in the
Epilog Contest VII

Participated in the
Robotics Contest

Participated in the
Make It Glow! Contest
16 Comments
7 years ago
very good?
Reply 7 years ago
Thank You but whats that question mark for ?
7 years ago
Good :D
Reply 7 years ago
Thanks :)
7 years ago
Hi tried it but couldn't make it to go. I really dont know whats wrong
2n2222a, resistor (metal) 1K Ohm
LED
copper wire from an old powersupply.
Does it needs 30 turns on the coil or can it be less.
Reply 7 years ago
It can be less not exactly 30 turns and make sure to strip insulation on the copper wire with sand paper
Reply 7 years ago
do I need to strip all insulation coating or only there where I have to solder.
Reply 7 years ago
only there that you have to solder
Reply 7 years ago
Also there is nothing wrong with your component try to watch the video carefully als i say it again make sur to strip the insulation coating on copper wire
Reply 7 years ago
do I have to strip all the insulation coating on the copper wire or only on the end points.
Reply 7 years ago
only on the ends
7 years ago
does it still work if i connect through a live wire?
Reply 7 years ago
to be honest I didn't understand ??
7 years ago
Hi, nice project, how thin the wire must be? Or it doesn't matter?
Thanks in advance.
Reply 7 years ago
It Really Doesn't Matter , I Got Mine From Transformer Of Old CFL Light Bulb Circuit . Thank You For Your Comment
Reply 7 years ago
Thanks!