How to Tie a Square Knot/Reef Knot

12,360

3

2

Introduction: How to Tie a Square Knot/Reef Knot

This is a knot to bond 2 strings together.

Step 1: Gather Your 2 Strings

Step 2: Step 1

Fold String 1 in on itself to create a loop

Step 3: Step 2

Put the end of String 2 through the look going under-over so thatString 2 comes to rest beyond the loop as shown in picture

Step 4: Step 3

Push String 2 Behind String 1 so that it comes out the other side

Step 5: Step 4

Push String 2 around the loop and back through the loop like in step 2 accept from the other direction

Be the First to Share

    Recommendations

    • Stone Concrete Cement Contest

      Stone Concrete Cement Contest
    • Build a Tool Contest

      Build a Tool Contest
    • Make It Modular: Student Design Challenge

      Make It Modular: Student Design Challenge

    2 Comments

    0
    MakerCL
    MakerCL

    10 years ago on Introduction

    thanks for the tip. I wouldn't use this for that anyways because there are many more practical knots for the job

    0
    mrmath
    mrmath

    10 years ago on Introduction

    Do not use the square/reef knot to bond to strings together if they will be put under load. In other words, if you'll be pulling on the two ends, don't use this knot. It can "capsize," which allows it to just slip off.

    http://en.wikipedia.org/wiki/Reef_knot#Misuse_as_a_bend

    The sheet bend is a more secure bend for joining two ropes.