How to Build an AC Power Switch Development Board

Introduction: How to Build an AC Power Switch Development Board

Ever want to create a design that automates turning on or off an AC powered device such as a light or a heating system? Well this Instructable is for you! In this video we look at how to create a development board for switching on and off AC power. The switch is implemented with a TRIAC which is a semiconductor device so no moving parts like a relay based design.

Be the First to Share

    Recommendations

    • Make it Glow Contest

      Make it Glow Contest
    • First Time Author Contest

      First Time Author Contest
    • PCB Challenge

      PCB Challenge

    5 Discussions

    0
    chakrihacker
    chakrihacker

    4 years ago

    I mean I want two switches like

    1. can be controlled with arduino(MCU)

    2.physical spst switch

    0
    ForceTronics
    ForceTronics

    Reply 4 years ago

    Yes you can add a mechanical switch in series or in parallel with the TRIAC.

    0
    chakrihacker
    chakrihacker

    Reply 4 years ago

    The problem with series is both the physical switch and mcu has to be turned on to turn on load and for parallel switch both the physical switch and mcu has to be turned off. I am looking for XOR logic

    0
    chakrihacker
    chakrihacker

    4 years ago

    How to add SPST switch to the switch board. So it can work as 2 way switch

    thanks in advance

    0
    ForceTronics
    ForceTronics

    Reply 4 years ago

    Hello, I am afraid I don't understand the question. The TRIAC is a SPST switch. Note that AC voltage swings positive and negative so you have current flowing in both directions.