Here's a quick tutorial of how to use L298N and Arduino to control DC motors

Step 1: All the Parts

Links for parts:

L298N Module:
Banggood

3-6V gear DC motor:

12V DC motor:

Helping hand:

4AA Battery holder:

Male to female cable:

Banggood

Amazon

Step 2: Codes

http://chenthedesignmaker.com/l298n-robot-how-to-drive-dc-motors-with-l298n-and-arduino/

Be the First to Share

Recommendations

Gandalf's Magic Staff by AaronHaras in Arduino

23 2.1K

2:3 Scale VT100 Terminal Reproduction by megardi in Computers

24 1.6K

TENEX - Solid State Volumetric OLED Display by seanhodgins in Electronics

77 6.0K

The Sheikah Slate From Breath of the Wild by Mastering Me in LEDs

122 10K

Pi Day Speed Challenge
Trash to Treasure Contest
Microcontroller Contest

4 Comments

unglaublich

2 years ago

looks good, i saw on banggood there is this rds3115, would this set up ( arduino+l298n
work with rds3115) work ???
thanks
have a good day
surv

gertha12

Question 2 years ago

I tried this. my two 6v dc motor work both perfectly. But when i try your setup. It just doesn't work. i used the simplel programme. Can you maby help me? I also added a picture of my setup.

inconceivable1

3 years ago

looks cool

Introduction: How to Drive DC Motors With L298N

Step 1: All the Parts

Step 2: Codes

Attachments

Be the First to Share

Recommendations

Pi Day Speed Challenge

Trash to Treasure Contest

Microcontroller Contest

4 Comments