Introduction: How to Make 3D Printed Rack Gear Slider With RC Servo 9G SG90
Description:
This is the 3D printed small rack gear slider. It is light and small, perfect for the small project which are involving in sliding, up and down lifter and else. The rack gear slider is controlled by Tower Pro Micro RC Servo Motor 9g SG90. The slider able to extend maximum 5 cm long and able to maintain certain extended length of slider. The rack gear can be attached easily to other hardware by locking the predesign M3 screw hole.
Specification:
- Origin: Malaysia
- Come with Tower Pro Micro RC Servo Motor 9g SG90
- Rotation angle: 0 degree - 180 degree
- Maximum extendable length: 5cm
Step 1: Material Preparation
