Introduction: How to Make a Car With Little Bits Controller by a Light Sensor

By
About: Mechatronics Engineer. Imagination is more important than knowledge. #Tinkering

This is a fan controlller by a light sensor , in this case we're using a 9V battery for power , a light sensor for control the DC motor. This can use for kids that are tinkering and creative.

Step 1: The Materials for This Project

  1. The materials are:
  2. 9V battery
  3. Power module
  4. Battery cable
  5. Mounting board
  6. Elastic band
  7. Light sensor module
  8. DC motor module
  9. Fork
  10. Wheel(2)

Step 2: Connect the Cable to the Battery of 9V

We proceed to connect the battery of 9V for power the circuit.

Step 3: Connect All the Modules

We proceed to connect the module power to turn on the circuit , then we connect the light sensor module that it´s configured in light sensitivity ,next we connect the fork for be able to connect more things , in this case two DC motor.

Step 4: Mount the Circuit in the Board.

Once the board is mounted you can put it on different ways of your choice, be creative!!