How to Make a Dog in Tinkercad
Intro: How to Make a Dog in Tinkercad
Here is a step-by-step tutorial on how to create a dog in Tinkercad.
STEP 1: Legs
Click and drag four cylinders into the workspace and place them like they were legs.
STEP 2: Body
Now add one more cylinder, this will be the body.
STEP 3: Body#2
Rotate the new cylinder by 90 degrees
STEP 4: Body #3
Now, make the body the size you want and change the height so it can rest on the legs.
STEP 5: Body#4
Drag the body on top of the legs.
STEP 6: Head
Now click and drag a sphere, this will be the head.
STEP 7: Head#2
Choose the size of the head you would like then lift the head to stick on one side of the body.
STEP 8: Eyes
Next, bring another sphere into the workspace.
STEP 9: Eyes#2
Now, decide the size of the eyes you would like.
STEP 10: Eyes#3
Copy and paste the one eye and make them a hole.
STEP 11: Eyes#4
Now decide the height of the eyes to match the head.
STEP 12: Eyes#5
Now place the eyes on the head in your desired position.
STEP 13: Ears
Next, drag a half cylinder into the workspace.
STEP 14: Ears#2
Change the angle of the ear, copy and paste it, then find the correct size for the ears.
STEP 15: Ears#3
Take the ears and place them on the top of the head where you would like.
STEP 16: Mouth
Next, place a "roof" shape into the workspace.
STEP 17: Mouth#2
Now rotate the mouth so that it is upside-down and make the mouth into a hole.
STEP 18: Mouth#3
Now place the mouth on the head, just below the eyes.
STEP 19: Tail
Now drag the final cylinder into the workspace, this will be a tail.
STEP 20: Tail#2
Next, take the tail and find the correct height and size.
STEP 21: Tail#3
Finally place the tail, and it should look similar to this in the end.
Comments
Penolopy Bulnick 8 months ago