Introduction: How to Make an Instructables Robot USB Drive

About: simplebotics.com covers the evolving world of robotics and drones.

This is a fun and inexpensive USB drive project, and to me it looks a lot better than regular usb drives!

Step 1: The Supplies

For this little instructable you are going to need the following:

1. Instructables sticker or Instructables robot print out(you can win the stickers from contests)
2. USB drive (doesn't matter how much memory it has)
3. scissors
4. pen
5. hotglue gun/hotglue
6. cardboard

Step 2: Tracing the Sticker/Print Out

Now get your cardboard and sticker (or print out) and lay it on top of the cardboard. Then get your pen and trace around the sticker.

Step 3: Cutting the Cardboard Out

Once you have traced the sticker on to the cardboard get your scissors and cut along the black line.

Step 4:

After that get your USB drive and put hotglue one side.

Step 5: Now Its Time to Apply

Get your cardboard and apply it to the hotglued side of the USB drive.

Step 6: Stick on the Sticker and Your Done

Now all you have to do is stick on the sticker (or apply some hotglue if your using a print out) to the cardboard and then you will have completed your very own Instructables USB drive!