How to Make the Knock Lock for Arduino Starter Kit

Introduction: How to Make the Knock Lock for Arduino Starter Kit

In this instructable i will be showing you a video on how I made a knock lock using the arduino uno starter kit. I did run into a few problems along the way but figured out a solution after thinking it over. this is the first arduino project I have made so i went solely off of the directions in the booklet provided in the kit. I may have gotten a bit ahead of myself when choosing to do the knock lock with no prior experience but i completed it and mostly to the manuals specification I hope you enjoy this instructable and I would appreciate any tips and suggestions that you have to offer.

Step 1: The Knock Lock in Action

click here to see my video on my overview of my project (sorry about my voice i was sick when making this). I had to rewire the piezo because not only was it not clearing the reset button the prongs on the bottom were not spaced as showed in the book so I had to use jumper wires to properly wire it then wire it to the piezo.

Sensors Contest 2016

Participated in the
Sensors Contest 2016

Beyond the Comfort Zone Contest

Participated in the
Beyond the Comfort Zone Contest

Be the First to Share

    Recommendations

    • Make it Glow Contest

      Make it Glow Contest
    • First Time Author Contest

      First Time Author Contest
    • PCB Challenge

      PCB Challenge

    Discussions