How to Do the Cobra Weave

Introduction: How to Do the Cobra Weave

About: Some of my favorite hobbies are woodworking, robotics, coding, cooking and creating more uses for Paracord are only some of the things I like to do throughout my free time.

To begin this was made for my other instructable "How to make a paracord key holder". This weave can be use for many thing such as tube covering, survival bracelets, key holders, etc. (Note: I didn't make this weave up or helped produce the making of this weave.)

Step 1: Supplies

The basic stuff you need is you hands and 2 strands of paracord.

Step 2: To Begin.

I created a jig to demonstrate how to make the cobra weave.

Step 3: Step 1

First you take either side of the outer paracord strands then you bring it under the middle strands but over the third strand.

Step 4: Step 2

Now you bring the red strand under the green strand.

Step 5: Step 3

Now you bring the red strand over the middle stands and the open green hole.

Step 6: Step 4

Bring the other/green strand under the middle strands and over the red strand.

Step 7: Step 5

Now with the red strand over the middle strands and thought the green opening.

Step 8: Finishing

Now continue alternating to create a cobra weave until you have reached the desired length.

Step 9:

Makerlympics Contest

Participated in the
Makerlympics Contest

Full Spectrum Laser Contest

Participated in the
Full Spectrum Laser Contest

Paracord Contest

Participated in the
Paracord Contest

Be the First to Share


    • Home and Garden Contest

      Home and Garden Contest
    • Science Fair Challenge

      Science Fair Challenge
    • Electronics Contest

      Electronics Contest