How to Make a Blow Dart for a Modded Nerf Gun

13,954

8

13

Introduction: How to Make a Blow Dart for a Modded Nerf Gun

Materials needed
1. q tip
2. needle
3. tape
4. nerf gun
5. have fun

Be the First to Share

    Recommendations

    • Game Design: Student Design Challenge

      Game Design: Student Design Challenge
    • Big and Small Contest

      Big and Small Contest
    • Make It Bridge

      Make It Bridge

    13 Comments

    0
    Rikudara
    Rikudara

    12 years ago on Introduction

    can you show how you fit the barrel cuz im having a lot of trouble with it

    0
    Higgs Boson
    Higgs Boson

    Reply 11 years ago on Introduction

    You pull the tip off of nerf dart, slip it onto the pin, put the pen in the barrel dart side first, and tape.

    0
    AyinYesh
    AyinYesh

    12 years ago on Introduction

    I made an explosive gas powered gun that fired these same exact darts about 3 blocks. I shot a can with one and the needle went straight through, and the q-tip just fragmented!

    0
    skyfaller
    skyfaller

    12 years ago on Introduction

    This woundt be sharp enough to pop balloons or anything like that, but instead of using a needle, i sed a common toothpick instead.

    I just shoved it in and it fit perfectly..


    For those who are going to use a toothpick, break the toothpick in half, then put the non - sharp part in the q tip.

    0
    A stranger
    A stranger

    12 years ago on Introduction

    This works very good on targets and water bombs I shot one at a water bomb my friend was holding the almost craped hinder I was just luck I didn't hit him but I almost pissed my self laugh. I like this mod but if I just put a pin through the top of a stream line bullet and it work just as good

    0
    rada194
    rada194

    Reply 12 years ago on Introduction

    glad you like it. My friend actually shot me with one on accident and it doesn't even hurt it doesn't have enough sharpness to pierce the skin. it fells just like a tiny little prick on your skin

    0
    A stranger
    A stranger

    Reply 12 years ago on Introduction

    Ok that is ur one. I make my own modified stream line darts 2 work in the nite finder and then I put a sewing needle in the orange cap. These stream line darts I make work upto almost double the standard stream line darts and work in any nerf gun. I am trying to publish this on the site but I am having trouble with doing it with the iPhone (universal nerf darts) I will let u no as soon as I publish it if u would like. Let me know if u get any more good ideas as this one u hav posted was very good. The ones I make r not blow darts though

    0
    johnnpikachu
    johnnpikachu

    Reply 13 years ago on Introduction

     No way it gets 240 feet. Not even a stefan dart with maximum moddage to the gun will get that much!!!