How to Replace a 72 Pin Connector for the NES Nintendo System

Introduction: How to Replace a 72 Pin Connector for the NES Nintendo System

A Step By Step Video on how to replace the 72 pin connector. It is really easy all that you need is a screwdriver. This will in most cases fix the blue or blinking screen issue that old NES systems tend to have. It's important to clean your cartridges before using them with the new connector. Otherwise you may end up having the same issue sooner than you would expect. Please watch and enjoy this was brought to you by Jeff at www.thebetatesters.org

Be the First to Share

    Recommendations

    • Toys & Games Contest

      Toys & Games Contest
    • Furniture Contest

      Furniture Contest
    • Big vs Small Challenge

      Big vs Small Challenge

    2 Comments

    0
    Heptron
    Heptron

    10 years ago on Introduction

    Hey there. I was directed to your video through an Instructable on NES cleaning with a Q-Tip and Windex. I'm a little leery about using Q-Tips for fear of leaving behind little bits of fuzz and I'm not sure what it is about the Windex that would clean off corrosion. What are your thoughts on cleaning games?

    0
    boogiesg
    boogiesg

    Reply 9 years ago on Introduction

    I probably wouldn't use windex. That's an ammonia based cleaner diluted with water and dyes. A #2 pencil Ruby Red Eraser is the recommended tool for cleaning the "golden fingers" on the game's edge connectors. Any thing more aggressive than that will only remove the gold electroplate, exposing the copper which will corrode much faster. 95% isopropyl alcohol will wash away grease and wax deposits.