Iron Man Pumpkin

Introduction: Iron Man Pumpkin

I've never actually carved a pumpkin before so I thought I'd give it a go. Better late than never. I wasn't going to put it on here hence why the steps are a bit rubbish.

Step 1: Stencil

I printed off the Iron Man face and taped it to the pumpkin. I used a nail to punch holes around the outline of the pumpkin

Once that was done I used a knife to take off the skin

Step 2: Carve!

After the initial skin was off its just a matter carving into the pumpkin to the depth that'll give the best glow. I used a sharp kitchen knife because that's all I had. A Stanley knife blade is good for scraping off extra layers

Pumpkin Contest

Participated in the
Pumpkin Contest

Halloween Decorations Contest

Participated in the
Halloween Decorations Contest

Be the First to Share

    Recommendations

    • Make It Modular: Student Design Challenge

      Make It Modular: Student Design Challenge
    • Tinkercad to Fusion 360 Challenge

      Tinkercad to Fusion 360 Challenge
    • Build a Tool Contest

      Build a Tool Contest

    Comments