Jamesdude's Oodammo Pistol

Introduction: Jamesdude's Oodammo Pistol

About: I am a knexer. HAPPY NOW?

This is an oodammo pistol I made when I saw the Mezak. Most of the oodammo guns I made were white rod thick guns, but when I saw the mezak, "Meh, what the heck, why don't I build blue rod thick guns?" So I did...

Stats:
30-40 ft w/ 1 #64
Very sturdy
Powerful.
Tilting mag
Shoots oodammo


Step 1: Body/Trigger

Follow the pics.

1. Make these.
2. Connect them the way I did.
3. Insides.
4. Another pic of insides.
5. Put the last two layers on.

Step 2: Mag

Here's my flip-mag.

1. Make these.
2. Connect them.

Step 3: Handle

Follow the pics.

1. Make these.
2. Connect them.


Step 4: Assembly

Follow the pics.

1. Connect handle.
2. Connect mag.

Step 5: Other Bits

Other bits.

1. Make these.
2. Put them in the gun.

Step 6: Rubberbands

Here's the rubberbands.

Step 7: Done!

DOOONNNEEEEE!!!!!!!!!!!! YOU GET A COOKIE!!!!!!!!!!!!!!! YAAAAAAAAAAAAAYYYYYYYYYYY!!!!!!!!!!!!!!!!!!!!!!!!!!!!

Be the First to Share

    Recommendations

    • Hour of Code Speed Challenge

      Hour of Code Speed Challenge
    • 3D Printed Student Design Challenge

      3D Printed Student Design Challenge
    • Hide It Challenge

      Hide It Challenge

    4 Comments

    0
    ~Aeronous~
    ~Aeronous~

    11 years ago on Introduction

     Very good. The trigger is better then Mezak, but the trigger is weak because it goes through the whole handle. Maybe try fixing that.

    0
    ~KGB~
    ~KGB~

    11 years ago on Introduction

    not bad, improve the handle a bit...