Jet Car

Introduction: Jet Car

Hello friends i am Ajay g, I am from Banjarapalya E4D Maker space.


  1. Water Bottel
  2. Strows
  3. Ballons
  4. Disco rubberbends
  5. Wheels
  6. Pen refills


  1. Scissor
  2. Hot glue

Step 1: Make a Whole in Watter Bottle

First we need to whole at the center of bottle and down wards of the water bottle.

Step 2: Putting the Straw at Water Bottel

Put the straw into the bottle which u make the wholes.

Step 3: Putting the Ballons Into the Straw

Fix the balloon into the straw by using Disco rubber remember close it properly the air will not come out.

Step 4: Put the Straw,balloon Into the Bottel

After that you must put the balloon and straw to the bottle, as shown in the image.

Step 5: Cutting the Straws

Cut the straws as much you want for the bottle.

Step 6: Fix the Cutted Straws

You have to fix the cutted straws to the bottle as shown in the image.

Step 7: Put the Wheels to the Car

Take some toys wheel and fix it to the straw, totally the jet car as been created so you can play with it.

Be the First to Share


    • Trash to Treasure Contest

      Trash to Treasure Contest
    • Science Fair Challenge

      Science Fair Challenge
    • Tinkercad to Fusion 360 Challenge

      Tinkercad to Fusion 360 Challenge



    6 years ago on Introduction

    Very cool little car. This looks like a lot of fun. Nicely done!